From mboxrd@z Thu Jan  1 00:00:00 1970
Date: Thu, 10 Aug 1995 17:13:42 -0400
From: presotto@plan9.att.com presotto@plan9.att.com
Subject: Question on network setup
Topicbox-Message-UUID: 158b79a6-eac8-11e9-9e20-41e7f4b1d025
Message-ID: <19950810211342.XwPp4gj3GdDqfC7c2gimR4y-SE8vthua-fI98Tiq5fg@z>

If /bin/ndb/cs can't figure out the name of the system, its because
it can't find the ether or IP address in /lib/ndb/local (or couldn't
open the ether device).  Clearly you think you've done this.  Could you
send me the relevant lines from /lib/ndb/local?

------ original message follows ------

>>From cse.psu.edu!9fans-outgoing-owner Thu Aug 10 17:12:10 EDT 1995
Received: by psuvax1.cse.psu.edu id <34155>; Thu, 10 Aug 1995 16:46:54 -0400
Received: from noao.edu ([140.252.1.54]) by psuvax1.cse.psu.edu with SMTP id <34152>; Thu, 10 Aug 1995 16:46:18 -0400
Received: from gemini.tuc.noao.edu by noao.edu (4.1/SAG-Noao.G102)
	id AA29575; Thu, 10 Aug 95 13:46:04 MST; for 9fans@cse.psu.edu
Received: from daikon.tuc.noao.edu.noao by gemini.tuc.noao.edu (4.1/SAG.sat.14)
	id AA09147; Thu, 10 Aug 95 13:46:03 MST; for 9fans@cse.psu.edu
Received: by daikon.tuc.noao.edu.noao (4.1/SAG.sun.8)
	id AA02374; Thu, 10 Aug 95 13:46:02 MST; for 9fans@cse.psu.edu
Date:	Thu, 10 Aug 1995 16:46:02 -0400
From:	rwolff@noao.edu (Richard Wolff)
Message-Id: <9508102046.AA02374@daikon.tuc.noao.edu.noao>
To:	9fans@cse.psu.edu
Subject: Question on network setup
Sender: owner-9fans@cse.psu.edu
Precedence: bulk
Reply-To: 9fans@cse.psu.edu

When my 486 boots, it prints out an error message that I need to
edit /ndb/local and reboot.  Having done that many times, it's clear
something else is wanted.  Also, /ndb/cs does not set sysname and the
local tcp network isn't available.  However, if I tell ip/ipconfig what
the ip address of my machine is by way of a command line argument, the
/ndb/local error message goes away, the network is accessible, and I
just have to mount #P and poke some routes at iproute.

Is there something I should do so the initial setup (aside from the routing)
happens automagically as the error message seems to imply?  (Gateway 486,
enet board WD8013EPC)

Richard