Suggestions for getting my PC to boot?

Suggestions for getting my PC to boot?

[presotto]

Have you checked that Linux and/or DOS can read the disk1
floppy?  In particular, do they see an a:\386\init?

------ original message follows ------

>From cse.psu.edu!9fans-outgoing-owner Sat Sep  9 12:34:03 EDT 1995
Received: by colossus.cse.psu.edu id <45812>; Sat, 9 Sep 1995 12:24:18 -0400
Received: from goggins.bath.ac.uk ([138.38.32.13]) by colossus.cse.psu.edu with SMTP id <45823>; Sat, 9 Sep 1995 11:55:08 -0400
Received: from bath.ac.uk (actually host solomon.bath.ac.uk) 
          by goggins.bath.ac.uk with SMTP (PP); Sat, 9 Sep 1995 16:54:49 +0100
Original-Received:  from 
                   GATEWAY by bath.ac.uk with netnews	for 9fans@bath.ac.uk 
                   (9fans@cse.psu.edu)
PP-warning: Illegal Received field on preceding line
To:	9fans@cse.psu.edu
Date:	Fri, 8 Sep 1995 19:49:50 -0400
From:	Troy Smith <tdsmith@idir.net>
Message-ID: <42qkqu$puc@sequoia.idir.net>
Organization: Internet Direct Communications -- (913) 841-2200
Subject: Suggestions for getting my PC to boot?
Source-Info:  From (or Sender) name not authenticated.
Sender: owner-9fans@cse.psu.edu
Precedence: bulk
Reply-To: 9fans@cse.psu.edu

I'm trying to install the 4-disk set on my PC, but am dying during 
the boot process.  I've tried three different versions of disk1 and 
used four different methods (raw floppy boot, running b.com from 
a fully-loaded DOS, running from the recommended bare config, and 
running from a minimal DOS boot (hitting l-shift @boot)), but it 
always dies in the same place with the same message:

2053 free pages, 8212K bytes, swap 45972K, highwater 408K, headroom 508K
CPU is a 66 MHz Intel486DX (cpuid: ax 400 dx 0)
fs...time...boot: /386/init: file does not exist
panic: boot process died: unknown

Then a table of 25 hex values followed by "exiting".

My system is an AMD 486DX2/66 with 12Mb RAM, 256K cache, two Conner
CFS420A hard disks, Cirrus Logic CL-GD5428, and various other things.
My motherboard is one of those strange ones with both types of SIMM 
slots (2 72-pin and 4 30-pin), with all 6 slots filled.  Linux has 
run on this system, so it can't be too bad.

Any hints on what would cause the preceeding will be appreciated, 
even if it means that I can't run it.

Thanks,

Troy Smith

P.S.  As an additional test, I pulled the 4 1Mb SIMMS to see if that 
      would help.  No luck.

Suggestions for getting my PC to boot?

[Troy]

I'm trying to install the 4-disk set on my PC, but am dying during 
the boot process.  I've tried three different versions of disk1 and 
used four different methods (raw floppy boot, running b.com from 
a fully-loaded DOS, running from the recommended bare config, and 
running from a minimal DOS boot (hitting l-shift @boot)), but it 
always dies in the same place with the same message:

2053 free pages, 8212K bytes, swap 45972K, highwater 408K, headroom 508K
CPU is a 66 MHz Intel486DX (cpuid: ax 400 dx 0)
fs...time...boot: /386/init: file does not exist
panic: boot process died: unknown

Then a table of 25 hex values followed by "exiting".

My system is an AMD 486DX2/66 with 12Mb RAM, 256K cache, two Conner
CFS420A hard disks, Cirrus Logic CL-GD5428, and various other things.
My motherboard is one of those strange ones with both types of SIMM 
slots (2 72-pin and 4 30-pin), with all 6 slots filled.  Linux has 
run on this system, so it can't be too bad.

Any hints on what would cause the preceeding will be appreciated, 
even if it means that I can't run it.

Thanks,

Troy Smith

P.S.  As an additional test, I pulled the 4 1Mb SIMMS to see if that 
      would help.  No luck.