Re: [9fans] PCMCIA 3COM 3CCFE574BT/3CXFE575CT 10/100

[jmk@plan9.bell-labs.com]

After this thread started I dug out a PCI 3Com card first to check
that worked OK before I started to look at the PCcard issues, and it did.
Of course, I may have used a different model to yours so if you can
get a PCI device listing (*pcihinv=1 in plan9.ini if you can't boot the
system enough to run /bin/pci). It's odd that a PCI card would have an
address at 0x300, that smacks of the card not being identified correctly
somehow.

--jim

On Mon May  1 05:47:54 EDT 2006, ajft@ajft.org wrote:
> jmk@plan9.bell-labs.com wrote:
> > i have some other pcmcia/cardbus changes in the pipeline
> > that might make a difference, but not quite finished. what
> > type of system and pcmcia/cardbus controller was it again?
> 
> Sorry if I've caused confusion, it is a PCI bus elnk3, not a PCMCIA
> card.  I'd responded to this thread since the problem appeared to be
> with 9load and all 3com cards, not just the pcmcia variants.
> 
> 9load identifies as: ether#0: elnk3: port: 0x300 irq: 5 ...
> 
> Machine is a PIII, 512M RAM, Award v4.51PG BIOS, Velocity 4400 video card.
> 
> > --jim
> 
> 	Adrian
> 
> ---------------------------------------------------------------
> Adrian Tritschler                          mailto:ajft@ajft.org
> Latitude 38°S, Longitude 145°E, Altitude 50m,      Shoe size 44
> ---------------------------------------------------------------