[9fans] kernel panics..

[Apurva Mehta <apurva@gmx.net>]

I posted a few days ago about kernel panics when I try to boot plan 9
from my hard disk. I have not been able to solve them yet. I have
been able to successfully boot Plan 9 from the bootable cd.

I have installed plan 9 on the second primary partion of my second
hard disk (primary slave). I tried installing it from the boot cd as
well as from an install floppy. I have also tried booting plan 9
straight of the hard disk as well as from a boot floppy.. Whichever
combination I try, I always wind up with the same error message. The
register values may change.

The error message I am including here is what I get when I try to boot
from my boot floppy. The 9load file on the boot floppy is the one
which Russ Cox was nice enough to send me yesterday.

---
PBS... Plan 9 from Bell Labs
ELCR: 0C20
apm ax=f000 cx-f000 di-1200 ebx=576c esi=C03e4
dev A0 port 1F0 config 045A capabilities 0F00 wdma 0007 udma 103F
dev B0 port 1F0 config 045A capabilities 0F00 mwdma 0007 udma 0407
dev A0 port 170 config 85C0 capabilities 0F00 mwdma 0407
dev B0 port 170 config 85C0 capabilities 0B00 wdma 0007 udma 0407
FLAGS=10246 TRAP=e ECODE=2 PC=***800298b4***
 AX 00000000 BX 00000000 CX 001f4f1b DX 00000000
 SI 0001e5f61 D1 81000000 BP 0bb1f04
 CS 0010 DS 0008 ES 0008 FS 0008 GS 0008
 CR0 80000011 CR2 81000000 CR3 ***00094000***
panic: exception/interrupt 14

Press almost any key to reset...
---

Here is my plan9.ini file..

---

bootfile=sdC1!fs!/386/9pcdisk
bootdisk=local!#S/sdC1/fs

*nomp=1
*nousbprobe=1
*noetherprobe=1
partition=new
mouseport=ps2
monitor=multisync75
vgasize=1024x768x32

---

I would love to be able to use plan 9 so any suggestions would be
greatly appreciated..

Thanks,

	- Apurva