Hello,

I have been trying to install plan9 for quite a long but never experienced a single boot ! (for installation)

Tried making a boot floppy (with plan9.ini) and also burning the ISO of 4th Edition. The ISO boots with my IBM ThinkPad T30 but wont go for its VGA. Whereas I have purchased a PC according to compatiability list, unfortunately it wont boot from the plan9 CD not from the floppy (it does support boot from CDROM, I have installed NetBSD on the same system), What I got from the boot on that PC is as follows ...

PBS...Palan 9 from Bell Labs
ELCR:0E20
apm ax=f000 cx=f000 dx=40 di=100 ebx=ef50 esi=ffff
dev A0 port 1F0 config 0C5A capiabilitie 2F00 mwdma 0007 udma 043F
pcirouting: South bridge 1022, 740B not found
Boot Devices: fd0 sdD0!dos
boot from: _

I think I am stuck here, I have read troubleshooting documents but what I can do at this "boot from" prompt ?

Please guide me in this, looking forward for a positive reply.

Regards,
Uzair