Hello,
I have been trying to install
plan9 for quite a long but never experienced a single boot ! (for
installation)
Tried making a boot floppy (with
plan9.ini) and also burning the ISO of 4th Edition. The ISO boots with my IBM
ThinkPad T30 but wont go for its VGA. Whereas I have purchased a PC according to
compatiability list, unfortunately it wont boot from the plan9 CD not from the
floppy (it does support boot from CDROM, I have installed NetBSD on the same
system), What I got from the boot on that PC is as follows ...
PBS...Palan 9 from Bell
Labs
ELCR:0E20
apm ax=f000 cx=f000 dx=40 di=100
ebx=ef50 esi=ffff
dev A0 port 1F0 config 0C5A
capiabilitie 2F00 mwdma 0007 udma 043F
pcirouting: South bridge
1022, 740B not found
Boot Devices: fd0
sdD0!dos
boot from: _
I think I am stuck here, I have
read troubleshooting documents but what I can do at this "boot from" prompt
?
Please guide me in this, looking
forward for a positive reply.
Regards,
Uzair