Re: [9fans] Re: Cannot boot with kfs error

[FJ Ballesteros <nemo@plan9.escet.urjc.es>]

Have you tried by copying the plan9.ini and the kernel from the
install to the hard drive?

(Beware that you'd need to edit the plan9.ini besides copying it,
at least to tell about the new kernel and boot disk)


Kiyoshi MATSUI wrote:

> Thanks Fco and Russ for reply.
>
> I am really using SCSI drives (sd03 is the forth drive).  The SCSI card
> has Symbios 53C875 chip.
>
> On Wed, 30 Apr 2003 12:00:06 -0400
> Russ Cox wrote:
>
>>Download http://plan9.bell-labs.com/~rsc/plan9/9pcdisk.apr30.gz,
>>write it to your boot floppy as 9pcdisk.gz, and set
>>bootfile=fd0!9pcdisk.gz to plan9.ini on the boot floppy.
>>
>
> I have tried the Russ's kernel.  The result, however, is the same (kfs
> error again).
>
> I have commented out the 'ether=rtl8139' line in 'plan9.ini'.  The pause
> of 10 minutes long, however, is not shortened.
>
> I have done again [copydist] in the installer.  The result never changes.
>
> Since the installer's plan9 works fine, including kfs and rio (except
> the problem of long pause), I think that my plan9 will certainly boot
> and work, as soon as the neccessary settings are done.
>
> What is lacking?  How can I investigate the problem?
>
>                                                                  kmatsui
>
>