hi,

http://plan9.bell-labs.com/wiki/plan9/installation_instructions/index.html


>The installer on the CD assumes that your CD-ROM is on the second IDE
master. If your CD->ROM is elsewhere, you will see the following error:

>Unknown boot device: sdD0!cdboot!9pcflop.gz
>Boot device: fd0
>boot from:

>IDE/ATAPI drives in Plan 9 are named like sdD0, where the capital letter is
C for the primary IDE >interface and D for the second. The digit is 0 for
the master and 1 for the slave. So if your CD->ROM is the primary slave, use
sdC1:

>boot from: sdC1!cdboot!9pcflop.gz

i think this should help. You need to explicitly specify the cdrom
drive you are using

hope it helps!

sameer

On 12/21/07, codewarrior85 <pcrkishan@gmail.com> wrote:
>
> Hi All,
>
> Am new to Plan 9. I burned the iso in a CD & tried to do a live Boot
> from the CD in one of my old laptop( P2  233Mhz 32MB RAM )....I got
> the boot screen ...I got the option screen & selected the option
> ( 2 ).....to run it in live demo mode....After i selected the
> option .....some thing came like.....Boot from fd0....I was not able
> to proceed further.........It jus kept asking me enter some value....
> Som one plz help me.......
>
> Thanx
>