I agree, if you have a choice avoid rpi by all costs.
Even if the software side of that other board was less pleasent at least it worked with my mouse and keyboard!! :)
As I said I was looking at 2Mbit/s stuff, which is nothing, even over USB. But my point is that even though this number is low, the rpi is too limited to do any meaningful processing anyway (ignoring the usb troubles and lack of ethernet). It's a mobile phone soc after all, where the modulation is done by dedicated chips, not on cpu! :)
On Wednesday, October 10, 2018, Digby R.S. Tarvin <digbyt42@gmail.com> wrote:
> I don't know which other ARM board you tried, but I have always found terrible I/O performance of the Pi to be a bigger problem that the ARM speed. The USB2 interface is really slow, and there arn't really many other (documented) alternative options. The Ethernet goes through the same slow USB interface, and there is only so much that you can do bit bashing data with GPIO's. The sdCard interface seems to be the only non-usb filesystem I/O available. And that in turn limits the viability of relieving the RAM contraints with virtual memory. So the ARM processor itself is not usually the problem for me.
> In general I find the pi a nice little device for quite a few things - like low power, low bandwidth, low cost servers or displays with plenty of open source compatability.. Or hacking/prototyping where I don't want to have to worry too much about blowing things up. But it not good for high throughput I/O, memory intensive applications, or anything requiring a lot of processing power.
> The validity of your conclusion regarding low power ARM in general probably depends on what the other board you tried was..
> DigbyT
> On Wed, 10 Oct 2018 at 17:51, hiro <23hiro@gmail.com> wrote:
>>
>> > Eliminating as much of the copy in/out WRT the kernel cannot but
>> > help, especially when you're doing SDR decoding near the radios
>> > using low-powered compute hardware (think Pies and the like).
>>
>> Does this include demodulation on the pi? cause even when i dumped the
>> pi i was given for that purpose (with a <2Mbit I/Q stream) and
>> replaced it with some similar ARM platform that at least had neon cpu
>> instruction extensions for faster floating point operations, I was
>> barely able to run a small FFT.
>>
>> My conclusion was that these low-powered ARM systems are just good
>> enough for gathering low-bandwidth, non-critical USB traffic, like
>> those raw I/Q samples from a dongle, but unfit for anything else.
>>
>