FYI, another item on my todo list is porting the RF24 library to plan9-bcm. i use nrf24l01+ devices between arduinos and a pi (in Go on linux) for temp/humidity telemetry.  the device uses the SPI interface.

on a somewhat related note, is anyone building support for Go on Plan 9/ARM?



On Fri, May 9, 2014 at 7:11 AM, Krystian Lewandowski <krystian.lew@gmail.com> wrote:
I was working on GPIO under Plan9 - very simple thing but also supports edge-raising/falling events. I had simple C code to print what pin triggered an event. I'll try to push this simple test to github during weekend. Though i'm not sure how it can be integrated - is events counting enough?

Krystian

2014-05-08 20:36 GMT+02:00 Bakul Shah <bakul@bitblocks.com>:

On Thu, 08 May 2014 18:58:31 BST "Steve Simon" <steve@quintile.net> wrote:
> I have a hifiberry (http://www.hifiberry.com/) nicely minimalist,
> though no driver at present - I will await the GSOC project :-)

> I have some itron VFDs from work, 256 x 64 pixel. I like these as
> the visibility is excellent. The only annoyance is they have
> a parallel interface and I use up all the PI's GPIOs.

> I also need to interface a rotary encoder for the tuning knob which
> is also a pain - not complex enough to justify an FPGA, but a bit too
> much to poll when the PI is doing audio decode as well.

No need for polling.  The BCM2835 can handle edge triggered
interrupts.  Or you can use a PAL or CPLD.

> Thinking of adding a PIC or an AVR just for the encoder / VFD interface
> and talking i2c to it.