the ZKP process involves 3 synchronous round trips. SRP used to have same problem but they can now do it in 1.5 round trips. On Thu, May 12, 2016 at 10:40 AM, Skip Tavakkolian < skip.tavakkolian@gmail.com> wrote: > it might be worth instrumenting the cpu command to time the authenticaiton > step. i think that's where the problem is. > > On Wed, May 11, 2016 at 3:39 PM Skip Tavakkolian < > skip.tavakkolian@gmail.com> wrote: > >> what's the latency caused by the auth step? >> FYI, from Seattle I see about 8 seconds to establish but as Charles >> noted, it's reasonably fast after that. >> >> >> On Wed, May 11, 2016 at 2:05 PM arisawa wrote: >> >>> Hello, >>> >>> we can measure the latency that comes from network connection >>> by executing simple program such as telnet or something others >>> to the port 8006 of grid.nyx.link. the content is: >>> #!/bin/rc >>> cat $net/local >>> cat $net/remote >>> >>> yes the DNS may make a problem in IPv4/IPv6 mixed environment. >>> my server supports both IPs. >>> the cpu command will select IPv4. the command does not have “-6” option. >>> If we want to connect by IPv6, literal IP address is required in the >>> argument of the command. >>> >>> Kenji Arisawa >>> >>> > In my experience, it's almost unfailingly the DNS that slows down >>> > establishing an Internet session of any type. >>> > >>> > Lucio. >>> >>> > 2016/05/12 0:23、Kenny Lasse Hoff Levinsen >>> のメール： >>> > >>> > Well, based on the 9fs test that was posted, I'd think dial is being >>> awfully slow. >>> > >>> > Maybe try something simpler? aux/listen1 echo hello and a simple >>> network connection? >>> > >>> > Best regards, >>> > Kenny Levinsen >>> > >>> > On 11. maj 2016, at 16.13, Charles Forsyth >>> wrote: >>> > >>> >> >>> >> On 11 May 2016 at 14:44, Kenny Lasse Hoff Levinsen < >>> kennylevinsen@gmail.com> wrote: >>> >> Delete the channel from /srv in the loop to test a full remote mount >>> dance, including the initial dial. It shouldn't take 3s to dial, though. >>> >> >>> >> There's something initially slow in connecting to grid.nyx.link with >>> cpu, and setting up, but once there it's fine. >>> >>> >>>