I'm trying to install Plan9 on a computer (256MB ram, Intel Celeron
2.00Ghz, 160GB hard disk). At the installation proccess, I go up to
part disk. Then it shows me that it made the new Plan9 partition
(2.45GB), so I type 'w' and 'q'. Then I get this:
Preparing menu... read: i/o error
and it prompts me again to partdisk, and it never ends. I really don't
think that this is the hard disks problem, it's a barely used 160GB
Maxtor drive. Has anyone had any problems similar to this? Could it be
because some of the hardware? (Unlikely, but...)
Regards,
Yosyp