hi charles, thanks for the details. regards dharani On Mon, Dec 22, 2008 at 6:03 AM, Charles Forsyth wrote: > for plan 9, for the older 4501 i think i had to eliminate some cga > references > in config and mkfile. use a mkfile without cga.$O (this > would be better done by specifying cga in the other config files, since > it's optional). > i used an earlier verson of the pcsoe config file below, but > had to add the dummy realmode this time to get it to compile. > that won't work unless there's a > plan9.ini as well with *norealmode=1 > i can't remember what i did for plan9.ini. > > for inferno i just needed a configuration file > because i'd once had to port it to a 386dx/16 without > cga, so i'd already made appropriate changes. > > dev > root > cons > arch > pnp pci > env > pipe > proc > mnt > srv > dup > rtc > ssl > tls > bridge log > sdp thwack unthwack > cap > kprof > > ether netif > ip arp chandial ip ipv6 ipaux iproute netlog nullmedium > pktmedium ptclbsum386 inferno > > sd > > uart > pccard > i82365 cis > > link > devpccard > devi82365 > ether83815 pci > etherwavelan wavelan devi82365 cis > ethermedium > loopbackmedium > netdevmedium > > misc > > uarti8250 > > sdata pci sdscsi > > ip > il > tcp > udp > ipifc > icmp > icmp6 > gre > ipmux > esp > rudp > > port > int cpuserver = 1; > void screeninit(void){} > void realmode(Ureg*){} > > boot cpu > il > tcp > > bootdir > bootpcsoe.out boot > /386/bin/ip/ipconfig ipconfig > /386/bin/auth/factotum > > ---------- Forwarded message ---------- > From: erik quanstrom > To: 9fans@9fans.net > Date: Mon, 22 Dec 2008 08:11:48 -0500 > Subject: Re: [9fans] plan9 > > - get plan9/inferno run on soekris net5501 board > > i thought plan 9 ran just fine on those. > > - erik >