Re: Cannot open load file: tool-bar

[Simon Josefsson <jas@extundo.com>]

Thomas Hungenberg <th@demonium.de> writes:

> Hi!
>
> I'm using Oort Gnus 0.06 with XEmacs 21.4 on Debian Linux which
> normally works fine. Now I wanted to debug a configuration problem and
> therefore added (setq debug-on-signal t) to my ~/.gnus.
>
> When restarting Gnus, it stopped with a signal complaining about not
> being able to load "tool-bar". So I tried to find the part of the
> configuration responsible for this error and finally cut down my
> ~/.gnus until it only contained the following:
>
> ,----[ .gnus ]
> | (setq debug-on-signal t)
> | (setq gnus-select-method '(nntp "news"))
> | (setq gnus-secondary-select-methods '((nnfolder "")))
> `----
>
> But even with this small configuration, Gnus still stops with the same
> signal:
>
> -----[begin of quoted message]------------------------------------------
> Signaling: (file-error "Cannot open load file" "tool-bar")
>   signal(file-error ("Cannot open load file" "tool-bar"))

Gnus triggers lots of non-fatal signals (240 according to grep -e
unwind-protect -e condition-case *.el|wc -l).  If you really want to
have debug-on-signal enabled, you will have to press `c' to continue.