From mboxrd@z Thu Jan 1 00:00:00 1970 From: IanK@vulcan.com (Ian King) Date: Tue, 9 Dec 2008 19:33:50 -0800 Subject: [pups] PDP-11 / vacuum tube interface In-Reply-To: <2f30dc950812091849gda4d77cy4428df8671149b8a@mail.gmail.com> References: <2f30dc950812091600t2028222dw3f855b2271a12593@mail.gmail.com>, <2f30dc950812091849gda4d77cy4428df8671149b8a@mail.gmail.com> Message-ID: In addition to the DECtalk standalone device, there was a Qbus module called DECVoice (DTC04) that was intended for telephone systems (voice response systems). I have the module in my personal collection; unfortunately, what I've been told is that there's a lot of others' intellectual property in the software (it's a microcoded device) so it would be a serious challenge to get the code to run it - too bad. -- Ian ________________________________________ From: pups-bounces@minnie.tuhs.org [pups-bounces@minnie.tuhs.org] On Behalf Of Ross Tucker [rjtucke@gmail.com] Sent: Tuesday, December 09, 2008 6:49 PM To: pups at minnie.tuhs.org Subject: [pups] PDP-11 / vacuum tube interface Dear all, (This has got to be the strangest cross-post I've ever done.) I have just taken a bet from a friend to challenge my geekiness. I was telling him about my love of Vintage Technology and he proposed that I combine two hitherto separate hobbies and see what happens. The topics: the DEC PDP-11 minicomputer (vintage: 1970s) and vacuum-tube ham radios (vintage: 1960s). I do sincerely apologize for cross-posting, but I am rather younger than either of these technologies (vintage: 1984) and this seems like a monumental challenge. My question for y'all: how could I possibly design+build a project that uses both of these technologies? My thought is to port some radio receiver Digital Signal Processing (DSP) application into PDP-11 assembler, compile and run it via emulator on my PC, then use it with the vacuum-tube regenerative receiver that I built a few years ago... Does anybody know if PDP-11 UNIXes even had the capability for a "sound card"? Or, to get ambitious, I would LOVE to design some interface circuitry between PDP-11 digital circuitry and vacuum-tube electronics... The challenges are legion: the tube side of the circuit operates around 350V DC levels with radio-frequency (RF) signals at 7 MHz (almost the clock rate of some PDP-11s!) and I don't have the DEC Handbooks, but I'm pretty sure that even those ancient pre-TTL circuits operate below 350V! So... any, er, "ideas"? Best regards, Ross Tucker CCed to: 'glowbugs' list at _______________________________________________ PUPS mailing list PUPS at minnie.tuhs.org https://minnie.tuhs.org/mailman/listinfo/pups