Re: Wireguard Neighborhood (IPv6)

[Jeroen Massar <jeroen@massar.ch>]

If you have something like the very common setup:

{internet} -> [wgserver] -> [wgclient] -> [local LAN]

Then if you have address space routed to wgserver, just route a /64 to wgclient and then normally radvd(&dhcpv6) it, done.

If you only have a single /64 on the server, then indeed you need to hack around with ndproxy.

But given that ISPs have near infinite IPv6 space... they should be able to route you a simple /64 and technically, from a RIR perspective should even be doing minimal /56 or even a /48...

Greets,
 Jeroen

--

> On 20210924, at 17:31, tlhackque <tlhackque@yahoo.com> wrote:
> 
> TLDR; It seems that WireGuard isn't supporting IPv6 NDP, and it should. 
> Use case & a work-around.
> 
> Full story:
> 
> Configuration:
> 
> WireGuard server (Linux, details below) behind a site router that
> handles IPv4 NAT & an IPv6 tunnel.
> 
> Server LAN has other hosts (and multiple subnets/vlans) - mostly dual stack.
> 
> The WireGuard server is able to access the WireGuard peers (clients)
> over IPv6.  The other hosts (and the router) are not.
> 
> The clients can't even ping the other hosts - the echo replies are
> generated, but they end up with an icmp6 unreachable.
> 
> It turns out that the other hosts (and router) send an icmp6 Neighbor
> Solicitation for the clients, which is never answered.
> 
> My interim solution was to implement
> https://github.com/setaou/ndp-proxy, which will respond with Neighbor
> Advertisements for the entire WireGuard subnet.
> 
> This is a rather crude solution - since ndp-proxy doesn't know what
> clients are connected, and since it requires one proxy process/wg interface.
> 
> It seems to me that WireGuard (in this case on the server) should at
> least be responding to Neighbor Solicitations for AllowedIPs of its
> active peers... Of course in the case of a WireGuard tunnel between two
> such sites, this is symmetric.
> 
> I did look at net.ipv6.conf.*.proxy_ndp, but that requires adding each
> address - and in any case I couldn't get it to work.  Neither did
> advertising the server as a "router" with radvd.
> 
> Unless I'm missing something, it seems to me that supporting NDP is the
> simplest "it just works" approach in any case...
> 
> wireguard-tools v1.0.20210424 - https://git.zx2c4.com/wireguard-tools/
> 
> Linux hagrid 5.13.16-200.fc34.x86_64 #1 SMP Mon Sep 13 12:39:36 UTC 2021
> x86_64 x86_64 x86_64 GNU/Linux
> 
>