Development discussion of WireGuard
 help / color / mirror / Atom feed
* Wireguard speed
@ 2021-04-16  7:49 Роман Строганов
  0 siblings, 0 replies; only message in thread
From: Роман Строганов @ 2021-04-16  7:49 UTC (permalink / raw)
  To: wireguard

Help with speed in the wireguard vpn.
There are 2 routers linksys with openwrt 19.07.7. And the wireguard 
tunnel between them.
If the link between the Wan of both routers is 1 gigabit/s, then the 
speed inside the tunnel is 300-370 Mb/s, which I think is good. I 
understand that these are simple routers, not servers.
This is done for the test.
In real life, the speed between the feasts will be limited to 100 Mb/s.
I decided to do a test and lowered the speed on the switch ports 
(routers connected through a gigabit switch) to 100 Mb/s. After that, 
the speed between routers through wg is 30-40 Mb/s. Processors on 
routers are loaded at 25-25%. Once I am on a channel in 100 Mb/s. 
received speeds between routers 85-90 Mb/s. So such speeds are possible 
on the wireguard.

After that, something went wrong with the electricity and the routers 
were rebooted. I didn't have time to save the settings.

 From memory, I set everything up again, but now I can't achieve high 
speeds...
I measure iperf3 installed on the routers themselves.

How can I get ~ 80-90 Mb/s again via 100 Mb/s channel?
I will be grateful for any help in setting the speed wireguard

p.s Forgive my English. I do not know him well and use a translator

^ permalink raw reply	[flat|nested] only message in thread

only message in thread, other threads:[~2021-04-17  0:10 UTC | newest]

Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2021-04-16  7:49 Wireguard speed Роман Строганов

Development discussion of WireGuard

This inbox may be cloned and mirrored by anyone:

	git clone --mirror http://inbox.vuxu.org/wireguard/0 wireguard/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 wireguard wireguard/ http://inbox.vuxu.org/wireguard \
		wireguard@lists.zx2c4.com
	public-inbox-index wireguard

Example config snippet for mirrors.
Newsgroup available over NNTP:
	nntp://inbox.vuxu.org/vuxu.archive.wireguard


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git