From: Carlos <linguafalsa@gmail.com>
To: ntg-context@ntg.nl
Subject: [NTG-context] Re: redefine space to be the same as \␣ similar to knuthian approach
Date: Fri, 18 Aug 2023 14:48:04 -0400 [thread overview]
Message-ID: <nf4c5cb5aryewtmo7umojrjk76y275yfkrtb7y4s2pylid2hob@ba2vwa7457pm> (raw)
In-Reply-To: <4svsfgwzru6i6ytxb4cbyywvx4vwr4jh5twlaonunzecux237r@jaedd3huwbf4>
[-- Attachment #1: Type: text/plain, Size: 7006 bytes --]
On Fri, Aug 18, 2023 at 02:26:55PM -0400, Carlos wrote:
> On Fri, Aug 18, 2023 at 06:20:29PM +0200, Mikael Sundqvist wrote:
> > Hi,
> >
> > It is extremely difficult to follow what you write.
> >
> > On Fri, Aug 18, 2023 at 11:43 AM Carlos <linguafalsa@gmail.com> wrote:
> > >
> > > If I have the following, with these linebreaks as in:
> > >
> > > {\par But a system cannot be successful if it is too strongly
> > > influenced by a single person. {\obeylines Once the initial design is
> > > complete and fairly robust, the real test begins as people
> > > with many different viewpoints undertake their own
> > > experiments.}}
> >
> > Is that the complete document? What do you have in mind with obeying
> > lines in the middle of a paragraph?
> >
> > >
> > > and opted to load another font, other than cmr that is, a \frenchspacing
> > > approach wouldn't be further required
> >
> > cmr? Not used in ConTeXt for a long time. (And what does the changing
> > of font have to do with this?)
> >
> > >
> > > Bear with me here, in the current state, for example, and as long as say
> > >
> > > «…person.␣{\obeylines Once the initial is
> > > complete…» though feasible enough, leaves any prior \␣ at the mercy of
> > > whatever fontsize and/or set width happens to be. And this is just plain
> > > wrong.
> >
> > What?
> >
> > >
> > > Likewise, if a word sequence such as \TeX\ occurs as in {\ss The separation
> > > of any of these four components would have hurt \TeX\ significantly. }
> >
> > Likewise what?
> >
> > >
> > > The next sentence: «If I had not participated…» does not get any
> > > \nofrenchspacing which is equally and doubly problematic. It shows lack of
> > > consistency. And this ought not to be an ‹either› ‹or› scenario. But
> > > rather, an and conjunctional construct. It fails both ways.
> >
> > Consistency of what? Spacing? Where? Can you make a complete example?
> > (You can show space amount with \showmakup[space])
> >
> > >
> > > Furthermore, with the same token, if width is specified with a
> > >
> > > \setuplayout[width=15cm]
> >
> > OK, here the game changes...
> >
> > >
> > > Anything less than 12.895pt, especifically for that use case, wwould
> > > throw anything, particularly control sequences such as \TeX\ out
> > > of whack, and conversely, once a value of that very pt or pica or
> > > whatever is lowered, it brings that nonfrenchspacing right back on.
> > > And if width increments occur, then it follows that any control sequence kerning
> > > also gets thrown off as a result.
> >
> > Of course the width influences the spacing. That is how the paragraph
> > builder works (and really, why it often looks good).
> >
> > >
> > > It seems so far, that with lmtx, any standalone file, document, minimal
> > > working example that does not load cmr at the outset does not produce
> > > an acceptable outcome either. By saying acceptable I meant to say it
> > > namely from a typographical point of view. Nothing else.
> >
> > I have no clue of what you talk about here.
> >
> > >
> > > from the TeXbook 380-381
> > >
> > > «\obeylines doesn’t say ‘\def^^M{\par}’, so we must make any desired changes to
> > > \par before invoking \obeylines. (2) The \uncatcodespecials operation changes a
> > > space to category 12; but the \tt font has the character ‘␣’ in the ⟨space⟩ position, so we
> > > don’t really want ␣12 . (3) The \obeyspaces macro in Appendix B merely changes the
> > > ⟨space⟩ character to category 13; active character ␣13 has been defined to be the same
> > > as \space, a macro that expands to ␣10 . This is usually what is desired; for example,
> > > it means that spaces in constructions like ‘\hbox to 10 pt {...}’ won’t cause any
> > > trouble. But in our application it has an undesirable effect, because it produces spaces
> > > that are affected by the space factor. To defeat this feature, it’s necessary either to
> > > say \frenchspacing or to redefine ␣13 to be the same as \␣. The latter alternative is
> > > better, because the former will discard spaces at the beginning of each
> > > line.»
> > >
> > > «In theory, this seems like it ought to work; but in practice, it fails in two ways. One
> > > rather obvious failure—at least, it becomes obvious when the macro is tested—is that
> > > all the empty lines of the file are omitted. The reason is that the \par command at the
> > > end of an empty line doesn’t start up a new paragraph, because it occurs in vertical
> > > mode. The other failure is not as obvious, because it occurs much less often: The \tt
> > > fonts contain ligatures for Spanish punctuation, so the sequences ?‘ and !‘ will be
> > > printed as ¿ and ¡ respectively. Both of these defects can be cured by inserting
> > >
> > > and
> > >
> > >
> > > «When INITEX creates a brand new TEX, all characters have a space factor code
> > > of 1000, except that the uppercase letters ‘A’ through ‘Z’ have code 999. (This
> > > slight difference is what makes punctuation act differently after an uppercase letter; do
> > > you see why?) Plain TEX redefines a few of these codes using the \sfcode primitive,
> > > which is similar to \catcode (see Appendix B); for example, the instructions
> > > \sfcode‘)=0
> > > \sfcode‘.=3000
> > > make right parentheses “transparent” to the space factor, while tripling the stretcha-
> > > bility after periods. The \frenchspacing operation resets \sfcode‘. to
> > > 1000.»
> >
> > Everything you cite above is very likely true for plain TeX, but maybe
> > not for ConTeXt...
> >
> > /Mikael
> >
> > PS I do not think that your emails come out well. In order to get
> > help, I would suggest a strategy that not so much only sounds as
> > nagging and complaints. One thing that has been lacking is a clear
> > explanation of what you really try to achieve.
>
> Mikael, I'll surely heed your advice with that strategy. It's almost
> impossible to have a decent looking pdf with lmtx
>
> kerning of a simple word sequence is off, along with spurious spaces
> interjected between sentences. What gives?
>
> And with luatex frozen for better or for worse, I better stick to plain
> tex
>
> --
> Thus spake the master programmer:
> "After three days without programming, life becomes meaningless."
> -- Geoffrey James, "The Tao of Programming"
>
> ___________________________________________________________________________________
> If your question is of interest to others as well, please add an entry to the Wiki!
>
> maillist : ntg-context@ntg.nl / https://www.ntg.nl/mailman/listinfo/ntg-context
> webpage : https://www.pragma-ade.nl / http://context.aanhet.net
> archive : https://bitbucket.org/phg/context-mirror/commits/
> wiki : https://contextgarden.net
> ___________________________________________________________________________________
--
They are relatively good but absolutely terrible.
-- Alan Kay, commenting on Apollos
[-- Attachment #2: Screenshot_2023-08-18_14-42-37.png --]
[-- Type: image/png, Size: 16868 bytes --]
[-- Attachment #3: Type: text/plain, Size: 495 bytes --]
___________________________________________________________________________________
If your question is of interest to others as well, please add an entry to the Wiki!
maillist : ntg-context@ntg.nl / https://www.ntg.nl/mailman/listinfo/ntg-context
webpage : https://www.pragma-ade.nl / http://context.aanhet.net
archive : https://bitbucket.org/phg/context-mirror/commits/
wiki : https://contextgarden.net
___________________________________________________________________________________
next prev parent reply other threads:[~2023-08-18 18:50 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-08-18 9:39 [NTG-context] " Carlos
2023-08-18 16:20 ` [NTG-context] " Mikael Sundqvist
2023-08-18 18:17 ` Carlos
2023-08-18 18:54 ` [NTG-context] unsubscribe Thomas Floeren via ntg-context
2023-08-18 18:26 ` [NTG-context] Re: redefine space to be the same as \␣ similar to knuthian approach Carlos
2023-08-18 18:48 ` Carlos [this message]
2023-08-18 18:58 ` Wolfgang Schuster
2023-08-19 13:32 ` Carlos
2023-08-19 14:06 ` Mikael Sundqvist
2023-08-20 13:38 ` Wolfgang Schuster
2023-08-20 15:51 ` Carlos
2023-08-20 16:41 ` Wolfgang Schuster
2023-08-20 16:58 ` Hans Hagen via ntg-context
2023-08-20 16:41 ` Hans Hagen
2023-08-21 12:22 ` Carlos
2023-08-21 12:55 ` Thomas A. Schmitz
2023-08-18 21:24 ` Hans Hagen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=nf4c5cb5aryewtmo7umojrjk76y275yfkrtb7y4s2pylid2hob@ba2vwa7457pm \
--to=linguafalsa@gmail.com \
--cc=ntg-context@ntg.nl \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).