Bug in command detection?

Bug in command detection?

[Richard Hartmann]

Hi,

when I install a program after I invoked ZSH and then try to call it, I get
a prompt asking:

  zsh: correct 'foo' to 'bar'? [N/y/a/e]

which is fine. I press enter, the command runs just fine, it exits and I
want to run foo again, it asks me yet again if it should correct the command.

I would assume checking the return code and remebering that this command
can be executed should be feasible, but I do, of course, not know.


In any case, thanks for all the work on ZSH,
Richard

Re: Bug in command detection?

[İsmail Dönmez]

Hi,

On Tue, Feb 26, 2008 at 11:59 PM, Richard Hartmann
<richih.mailinglist@gmail.com> wrote:
>  when I install a program after I invoked ZSH and then try to call it, I get
>  a prompt asking:
>
>   zsh: correct 'foo' to 'bar'? [N/y/a/e]

Run rehash and it'll learn newly installed commands.

Regards,
ismail

-- 
Never learn by your mistakes, if you do you may never dare to try again

Re: Bug in command detection?

[Richard Hartmann]

On Tue, Feb 26, 2008 at 11:09 PM, İsmail Dönmez <ismail@namtrac.org> wrote:


> Run rehash and it'll learn newly installed commands.

Yes, I know. My point was that zsh _knows_ about this one single new
command being available, though.


Richard